****Elite v2 Bottom Feeder - Presentation***

It`s been a while since I came up with something new so here goes ...
I`m a fan of squonkers but I wasn`t all that satisfied with the designs
that I`ve seen so far - there always was something that didn`t suit me
100% so I decided that it`s time to go back to the old drawing board.

Let me show you what I came up with - finally I`ve managed to make a
bottom fed mod that is made of one piece of wood (I`m not a big fan of
moving parts when I can avoid them),
dna, easy to fit a bottle and you always have a finger on the bottle -
no more trying to squeeze a bottle through a small window or sticking
out plungers.
I`ve taken my old Elite V2 design and worked around
it to make a bottom fed box that`s ergonomic, not too big and that can
be operated with ease.
It`s no thicker than an elite v2, 10 cm tall and only 6 cm wide.
Capacity of bottle is 10ml

The upper hole is there to make it easier to attach the bottle to the
connector - it`s quite hard to do it if you can`t see anything and I
wouldn`t want anyone to try to fit the bottle and fail.
For now it`s
a prototype that I`m testing and I wanted to ask what you guys think
before I send it out to a buddy of mine in the USA for some more
testing.
Some things might change, but for now I`m quite happy with
it - bottle is easy to use and even easier to install, I avoided all
the magnets and stuff and managed to avoid flaps/doors and the need to
open the mod

If you want you can share this info on FB and forums - I`m rather busy and can`t do it on my own, but I`d love some feedback

thanks

Answer for some PM's question:

- I working on 23mm catch cup, so If I manage to get a 23mm catch cup
connector you`ll be able to use any atty you want - and I`ll do my best
to do that.

- As for leaking and so on - that`s what this
prototype is for. I want to see how well will it work and improve/change
if something doesn`t work as planned. Even if you`d have a leak then
that`s not that big of a problem - it won`t touch the electronics or the
battery and you can just clean it up with a q-tip. The wood is
stabilized, so it`s very resistant to eliquid and any other type of
moistur

- The upper hole is there to make it easier to attach the
bottle to the connector - it`s quite hard to do it if you can`t see
anything and I wouldn`t want anyone to try to fit the bottle and fail.

- Bottle is 10ml , dimensions of the box are: around 10cm x 6cm x 3cm

- battery is 1x18650